Subscription Services: Subscribe | Change | Unsubscribe | RSS
Advertising Media Kit: Introduction | Rates | Testimonial | Contact
Miscellaneous: Reference Desk | Sitemap

Scuba Mask Swivel Recalled Over Defect; 'Sudden Loss Of The Diver's Air Supply'

print this print      Bookmark and Share   RSS 2.0 feed

WASHINGTON, D.C. -- M&J Engineering is recalling about 1,500 swivels for scuba masks.

The swivel, which is attached to a diving mask, could separate while diving. This will result in a sudden loss of the diver's air supply, causing the diver to engage in emergency ascent. This poses a risk of decompression sickness due to rapid ascent or drowning.

M&J Engineering has received one report of swivels separating from the masks while diving. No injuries have been reported.

This recall involves all SW-3000 2nd stage 360-degree swivels for scuba diving masks manufactured between January 2004 and February 2005. The swivel has the date stamped on its body, below the patent number. Swivels that are already repaired have an arrow stamped on the top right corner of the swivel body.

The swivels were sold at diving retail stores nationwide between January 2004 and February 2005 for about $60.

Consumers should immediately stop using the scuba diving masks with the swivel attached and contact M&J Engineering to receive a free repair.

Consumer Contact: For additional information, contact M&J Engineering toll-free at (888) 794-8351 Monday through Friday between 8 a.m. to 5 p.m. PT, or visit the company's Web site at www.mj-engineering.com.

The recall is being conducted in cooperation with the U.S. Consumer Product Safety Commission (CPSC).

Views expressed in this article do not necessarily reflect those of UnderwaterTimes.com, its staff or its advertisers.


bottom_left
bottom_right
Privacy Policy     © Copyright 2019 UnderwaterTimes.com. All rights reserved